1◕✘╃✘╃、 Measurement of curved arm sunshade:

遮陽棚寬度（以下簡稱篷寬）及三種類型陽臺測量的確定

Determination of awning width (hereinafter referred to as awning width) and measurement of three types of balconies

1◕✘╃✘╃、凹式陽臺

1. Concave balcony

首先↟││·◕，用米尺測量現場陽臺的極限寬度（此尺寸為遮陽棚能安裝的理論極限值）✘◕•。 篷寬為以上極限尺寸再減去50mm（此尺寸為遮陽棚能安裝的實際極限值）✘◕•。

First, measure the limit width of the balcony on site with a meter ruler (this dimension is the theoretical limit value that the sunshade can be installed). The canopy width is the above limit dimension minus 50mm (this dimension is the actual limit value that the sunshade can be installed).

2◕✘╃✘╃、半凹式陽臺

2. Semi concave balcony

首先↟││·◕，用米尺測量現場陽臺的極限寬度✘◕•。

First, measure the limit width of the balcony with a meter ruler.

篷寬為以上尺寸再減去50mm↟││·◕，此尺寸是從遮陽棚安裝的對稱角度考慮✘◕•。實際尺寸可按客戶的要求適當加長↟││·◕，但加長幅度**按陽臺的寬度及安裝腳位置另作計算✘◕•。

The awning width is the above dimension minus 50mm, which is considered from the perspective of symmetry of sunshade installation. The actual size can be appropriately extended according to the customer's requirements, but the extension range * * is calculated separately according to the balcony width and installation foot position.

3◕✘╃✘╃、開放式陽臺

3. Open balcony

首先↟││·◕，用米尺測量現場陽臺的極限寬度✘◕•。 蓬寬為以上測量尺寸✘◕•。實際尺寸可按客戶的要求兩端適當加長↟││·◕，但加長幅度**按陽臺的寬度及安裝腳位置另作計算✘◕•。

First, measure the limit width of the balcony with a meter ruler. The canopy width is measured above. The actual size can be appropriately extended at both ends according to the customer's requirements, but the extension range * * shall be calculated separately according to the width of the balcony and the position of the installation foot.

二◕✘╃✘╃、天頂式遮陽棚的測量│·◕│☁：

2◕✘╃✘╃、 Measurement of canopy type sunshade:

天頂式遮陽棚一般安裝在戶外陽光房上面↟││·◕，根據陽光房的實際尺寸及客戶要求而定✘◕•。 根據陽光房的房頂而傾斜✘◕•。如果陽光房為平頂↟││·◕，可與客戶協商適當給出斜度✘◕•。

The ceiling sunshade is generally installed on the outdoor sunshine room, which is determined according to the actual size of the sunshine room and customer requirements. According to the roof of the sunshine room. If the sunshine room is flat roof, the slope can be given appropriately through negotiation with the customer.

三◕✘╃✘╃、窗式遮陽棚的測量│·◕│☁：

3◕✘╃✘╃、 Measurement of window sunshade:

窗式遮陽棚安裝在窗子的外面↟││·◕，分為框內安裝與框外安裝； 實際尺寸│·◕│☁：根據現場遮陽棚能安裝的實際極限值及客戶要求而定✘◕•。

The window sunshade is installed outside the window, which is divided into in frame installation and out of frame installation; Actual size: determined according to the actual limit value that the sunshade can be installed on site and customer requirements.

四◕✘╃✘╃、確定操作方式及方位│·◕│☁： 操作方式│·◕│☁：手柄操作和馬達操作；

4◕✘╃✘╃、 Determine the operation mode and orientation: operation mode: handle operation and motor operation;

操作方位│·◕│☁：左邊操作◕✘╃✘╃、右邊操作及室內操作；

Operation orientation: left operation, right operation and indoor operation;

注意│·◕│☁：操作方位的確認——人始終站在遮陽棚的對面為基準✘◕•。

Note: confirmation of operation orientation - people always stand opposite the sunshade as the benchmark.